AC500 and 5 Batteries powering everything here and more.
Also powering Fridge, coffee maker, washer&dryer, 2 ceiling fans, 2 AC window units running 24/7, music gear, 11 powered speakers plus sub, wifi/modem.
.
Just got the rolling platforms rated at +300 pounds. You can’t stack both columns against the wall because those power cables are just a bit too short, so I had to position them like you see.
.
My old Kill a watt meter bit the dust so I splurged for the Bluetooth/wifi model with bells and whistles. A lot easier to read on my ipad app instead of crouching over with a flashlight.
.
Both ACs and Fridge run 24/7 and the solar panels take over before the batteries get to low. By 2pm they are recharged back to 100%.
5 Likes
Awesome setup - Thank-You for posting!!
1 Like
wow lovely setup - looks like the perfect addition to a healthy mancave 
1 Like
@BLUETTI or Can someone please send me a diagram how to build home back up set up for ac200max. I am not an electrician or knowledge about electricity. I live in Philippines using 220v from the grid. thank for the response …newbie here.
Sounds like a nice setup @Poppy. I like the simplicity and DIY approach you took with it. And also how flexible you can be with it. 
Hello. I am also in the Philippines. Looking at a AC200Max and a couple of panels. I have no need for aircon. so this set up and later an extra battery would do. I wish to connect the set-up to my breaker box and distribute in the entire house. I only need the grid as a backu in case of not much sun. I am also looking for a schematic / idea. Did you receive anything? If you are interested we could chat in privat? Rgs Mike
AC200MAX is an off-grid machine that can be used directly by plugging in a load. However, its capacity is too small, so it is not recommended to connect it to the home power grid. We also do not have relevant wiring diagrams for it. Only the larger models, AC300 and above, have wiring documents available.
My Solar Setup - Home Backup.
I have AC 200 MAX.
1 635W (3x 545W) on the Roof. 900W via MPPT and 500 via DC Enhancer. It powers my Boiler, AC, dryer, and Washing Machine and charges my Ryobi. And connected to Home Assistant. Absolutely love it.
5 Likes
Beautiful setup! How sunlight in your area during Autumn, Winter and Spring?
I think not ideal (Czechia) but not bad either. I have the setup just for few days, so not enough data 
.
All the panels are facing south without any shade on them from any object.
4 Likes
very promising! enjoy
howdy Mike. unfortunately none. According to Bluetti ‘Only the larger models, AC300 and above’
thanks for the response. So I guess I am really going to AC300 which I am also eyeing besides ac200max.
It’s possible with a transfer switch (here you can select grid or bluetti). Just be sure you keep your load under 2200W. You just plug the transfer switch into Bluetti with a classic AC cable. But still, this needs an electrician. They are made for generators (gasoline) but work the same way with bluetti.
3 Likes
I have a system similar to yours. AC200MAX plus 2 B230s powered by 8 - 180 watt solar panels. Originally I had all 8 panels in series putting out 1440 watts but this was wasteful since the AC200MAX would only accept a maximum of 900 watts through the PV port. So I divided the panels into 2 groups. One group of 5 panels supplies 900 watts to the PV port and 3 panels supply 540 watts through a DC Enhancer into the AC input port. I used to be an electrician so I installed a 4 circuit manual transfer switch attached to the main breaker panel. The primary purpose is to supply power in the event of a grid outage but I use the system all the time to power a fridge and my wife’s home office. Of course the system is too small to power the whole house but I can cover essential services.
4 Likes
The way my house is arraigned I’m powering almost everything without being hooked up to the house wiring. I already had plenty of power cords from being in a band, so they run into the kitchen and my bedroom. The house lights are about the only thing not connected to the AC500, but all my bulbs are low wattage LEDs anyway so it’s not worth the effort to install a transfer switch.
While all my neighbors are getting $200-$300 power bills here in Vegas, mine averages $40 because instead of using my central HVAC, I have two window A/C units running 24/7, solar powered of course. They are enough to cool the whole house.
3 Likes
Sounds great @St8kout - something I’d love to get to as well. At the moment I’m only using the EB3A with a small, portable soalr panel. But it powers a laptop, router, light, and charges phones etc. We get plenty of sunshine where I am and I’d like to be less dependent on the grid, so I’ve started experimenting with solar energy. So your setup is quite inspiring to me.
2 Likes
Thanks for sharing Zkaza!
Agree- I have my AC200 Max connected to my transfer panel and use it to power 4 essential circuits ( not the whole house) during an outage. Staying under 2200 watts is relatively easy , and if i use my coffee maker or microwave, I just turn off my boiler and fridge circuit for the time that i am using it - little extra work doing this, but I dont mind, as I am just very happy that I can still use these items this during an outage!
Sept 2024 Update - I am still enjoying my system and I am using it on sunny days to power my 4 essential circuits and in doing so have noticed a modest decrease in my electrical bill. When i do, I flip the circuits over in the morning to be powered from the Bluetti and also turn on the input from my 395 Watt panel. I usually leave it like this until early evening when the sun is no longer on the panel - I then flip back to grid power. If i start with a 100% charge in my system, i usually end up at approx anywhere from 92-100% charge at the end of the day, so am happy with this result. After a couple of days of doing this, when my system gets down to about 80% ( or so) , I turn the panel input on and leave the essential circuits powered from the grid - I can bring my Bluetti system back up to 100% the same day. Late last year my neighbor saw my system and I told him all about it - he bought everything that I had, as he didnt want to be stuck without power anymore during an outage. I used the Bluetti referral program and was awarded the Bluetti Bucks! He then showed a work colleague of his his system and told me that his colleague ended up buying a Bluetti system as well. So there you go - be an ambassador for Bluetti and let your friends and neighbors know about what a Bluetti system can do for them during power outages which in many areas are happening more and more frequently. Would love to see some more AC200 home back up systems added to this post with your story!
1 Like